Specs, Inventory and additional information

Builder - Alumet Tacoma WA 1975

Designer - Ed Monk Sr.

Dimensions

• LOA - 60

• LWL - 40

• Beam - 16'8"

• Draft - 6"

• Displacement - 60,000lb

• Bridge clearance - 68'

Tanks

• Fresh water - 300g

• Fresh water flushing heads - 100g

• Holding (grey) - 100g

• Holding (black) - 100g

• Fuel - 300g

 Propulsion

• Main - John Deere 4.5L  TFM4045 Turbo commercial duty marine diesel (350 hrs)

• Transmission - Twin Disc 5053  2:1 Ratio

• Prop - 24" x 22" Bronze 3 Blade

• Shaft - 1-1/4" stainless steel

• Transmission cooler (seawater cooled off main)

• PSS dripless shaft seal

• Engine exhaust - 4" Centek primary water lift muffler, 2 secondary resonators, anti-siphon loop, port side hull exit at waterline.

• Steering - Wagner hydraulic A series pump

• Bow Thruster - Vetus 12 Volt 12hp  8" bow tube

Electrical / Electronics Navigation

Inside Station

• Toshiba Laptop w/Maxsea navigation software and CMap world charts

• Standard Horizon Gx3000s VHF/Hailer

• Standard Horizon 150c GPS/chartplotter

• BG network depth

• John Deere engine instr panel

• Raytheon R20XX 36 mi radar

• Wood Freeman 500 series autopilot (factory rebuilt)

• Engine controls

Cockpit

• Globemaster compass 6" card

• Full engine instrumentation

• Bow Thruster controls

• Engine controls

• Remote VHF mic control

Battery Banks

• Starting - 8D with dedicated 80 amp alternator off main

• House - 800 amp hr - 8x200 amp hr 6 volt golf cart flooded cell in series

• House charging - 200 amp alternator off main with Balmar 3 stage voltage reg.

• Wind Generator - Ampair 100 marine

Distribution system

• Anchor marine grade tinned cable throughout

• All runs terminated on breaker panel and labeled

• 50 Amp Isolation Transformer

• Xantrex Prosine 3.0 - 3kw inverter / 120 amp charger

• Split bus 30 amp x 2 shore power connections

Deck

Ground Tackle

• Main Anchor - ForFjord (Seattle)  #12 - 140lb (rated by mfg up to 80 vessel)

• Secondary (stern) - Danford (high tensile) 60lb

• Windlass - commercial hydraulic drum style

• Rode - 200' x 1/2" chain followed by 400' x 1/2" high tensile galvanized cable

Sail inventory

• No 1 Jib (hank on) (good cond)

• 1.5 oz spinnaker with 25' aluminum pole (good cond)

• 1.5 oz asymmetrical spinnaker (good cond)

• offshore weight stay'sl (excel cond)

• offshore weight mainsail 2 reefs(excel cond)

• offshore weight mizzen sail 2 reefs (excel cond)

Sail handling winches

• Mainmast - 3 bronze

• Main boom - 2 bronze

• Mizzen mast - 2 chrome

• Mizzen boom - 1 bronze

• Cockpit - 1 mainsheet, 1 mizzen sheet, 2 jib/spinnaker, 1 stay'sl

• Halyards are wire rope combo - all Samson low stretch 5/8"

Standing rigging

• Mainmast - Aluminum 60' - 8"x10" section,

• Mizzen - Aluminum 48' - 6"x8" section

• Total 24 wires, holding up masts, min 3/8" cable, all staylok fittings, extra heavy duty galvanized turnbuckes

• Very strong, redundant capacity, offshore rigging

Galley

• 110 volt industrial series refrigeration compressor / holding plate system

• setup to run on shore power, generator or inverter

• Splendide Combomatic 2000 washer dryer

• 12 cubic foot freezer, 14 cubic foot refer -- top loading, heavily insulated

• Magic Chef 4 burner propane stove with oven

• Microwave, toaster oven

• Center island with double stainless deep sinks on centerline

• Aquasana in counter drinking water filtration system

• 20 Gal Superstor water heater, only 5 degree temp drop in 24hrs

• Island Marine 20gal hr/ 500gal day water maker

• Insinkerator waste disposal in one sink, outflows to grey water tank

• Total of six opening hull portholes for cross ventilation

• 2 - 2'x3' opening ceiling deck hatches

• Dining settee provides seating for six with drop down sleeping accommodation

• Plenty of storage throughout

Accomodations

The first thing one notices in stepping below on Salome, is that you don't feel like you have stepped "down below" into a sailboat. The main salon is an immediate surprise in it's openess and brightness. Measuring almost 12'x12' it feels more like a small living room than a boat cabin. Surrounded by large tempered glass offshore windows, one has a 270deg panoramic view of what's around you. Looking aft, this salon is open to the gallee, which is 2 steps down and aft, making for a main living area that is half the total accomodation space on board. This is where you'll spend most of your time in a social setting. The inside control station is port and froward, with a matching chart desk on the starboard side. Below the waist height windows on the main salon are featured storage lockers and drawers both port and starboard which encompass the width of the side decks. Also on this level tucked into one of these storage locations is the compact all in one washer dryer

Stepping down 2 steps and forward through the centerline companionway from the main salon are the 2 main accommodation cabins. The port side cabin has the extra large double bunk, adjoining larger head, hanging locker, chest of drawers and access to the standalone shower.

Centerline companionway and to starboard is the second double cabin, again with it's chest of drawers, hanging locker, through which leads entry to the second head, of which access is gained to the forepeak cabin with it's over and under bunks. The second head also has access to the shower, vanity, sink, and locker space.

It's important to note that all accommodation cabins have at least 2 opening hull ports and a large 24"x24" opening deck, ventilation/escape hatch.